What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 12:00
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
He then describes Rainy Season and Lightning.
At least they know the answer if they wanted it.
China Set for Critical Orbital Refueling Test With 2 U.S. Satellites Watching Closely - Gizmodo
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is where the MOV conducts again, and dissipated the energy.
Costco makes key moves to protect prices from tariffs - TheStreet
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This one hit behind the barn.
2024–10–16 [ OO OLAOYE OYEBODE ]
What are some sex stories from your college days?
eight
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What does a fuse do?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Don't miss the half-lit first quarter moon rise tonight — Here's what to look for - Space
2024–10–10[John johnson John Johnson ]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
He then asserts :
iFixit is retroactively giving the Nintendo Switch a 4/10 on repairability - The Verge
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
For this case there are devices called Metal oxide varistors (MOV).
[old diagram got deleted by accident]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
What is lightning?
Hypertension: New drug shows strong results in managing blood pressure - Medical News Today
The other is “what does a “fuse” do?”
Edit 2024–10.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, what happens?
These devices are installed between the “hot” and “neutral” and protective ground.
At one ohm, the resistor has a maximum of 1 watt power.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Now when you have a certain ac resistance, then a current flows in a loop.
One
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This device then solves the entire problem.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
An AC voltage/ current source, and an ac inductive load.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Rory McIlroy destroys tee marker but survives cut at U.S. Open - NBC Sports
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Because the load is inductive, the current lags the voltage.(by a bit).
Canadian Robot Finds a Weight Beneath the Ocean Equivalent to 250 Million Elephants - Jason Deegan
but I think this circuit , shows a few more pieces.
Barnstars:
So, the voltage could go up to 500 volts, and the fuse will not open up.
a photo is worth a thousand words.
This is where this question deviates from being a 'generic' question, and becomes more specific.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
what exactly is a ‘surge’ protector?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
But it can get overloaded, and no longer works.
He then describes the function of a fuse.
First Sentence:
Upvotes:
It also is a device that limits the change in current flow.
(Dc diagram shown, AC is similar).
The bolt then partially travels down the line to your home.
There are three different concepts here that are getting confused.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
but this device (an Inductor) … impedes the rapid changes in the current.
A circuit breaker is similar, but is resettable.
The MOV will conduct when the voltage exceeds 50% of line voltage.
A fuse is a non-resetable over current circuit protector.
In schematic diagrams this is the symbol for a fuse:
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is 'the assistant's answer'
2024–10–14 [Omar Gharbi Omar Gharbi ]
One is “what exactly is in a ‘surge protector’ ? ”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
There are two important concepts here.
the problem then depends on "how fast does the fuse operate?".
It seems Mohan does not understand the difference between a comment and an Answer.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
I post the exact comment here.
Here is a simplified AC power diagram.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
But… the neutral is now “floating” because of the 1 ohm resistance.
These are simplified answers to the original question, and does not change anything I wrote above.
nine
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.